1. Check whether there are foreign objects in the crushing chamber (must be empty before starting), and connect the power supply.
2. Tighten the butterfly nut on the upper cover and crushing cavity.
3. Start the motor, rotate the empty machine for 1-2 minutes, and then gradually feed the beaten material from the feeding tray.
4. If the material is stuck and the motor does not turn, please turn it off immediately to avoid burning the motor. After the stuck material is removed, you can continue to use it.
5. During the use of this machine, it is strictly forbidden to open the upper cover and reach into the crushing cavity by hand.
6. This machine is a dry crusher. It is not suitable for crushing wet and greasy materials.
7. Please change different screens according to your needs.
8. This machine adopts overheat protector. If the motor load is too large, it will automatically stop. If you continue to operate, please press the protector again.
9. During the operation of this machine, the current shall not exceed 15 amps.
Diamond Painting, also known as Diy Diamond Painting, is an organic combination of exquisite and shining artificial crystal flat-bottomed round diamonds (some square diamonds) and well-designed patterns. Paste it on the corresponding color point on the canvas, thus completing the paste of a diamond, you can get started in a few minutes, and then slowly fill in each color area, a 40CM*40CM diamond painting only takes 2 hours It's done in about a minute. With the continuous development of diamond painting, it has now extended to innovative products such as 3D diamond painting and 5D diamond painting.
Diamond Painting,5d Diamond Painting,Diy Diamond Painting
Dongguan Junkai Packaging Products Co., Ltd , https://www.diystoragecases.com