To calculate and modify the exposure time according to the sample, we must first know that the three factors that cause the exposure time to change in the color calibration process (ie, the density of the color correction filter, the number of sheets, and the sample density, etc.) are at the exposure time. Change the value and then calculate the new exposure time based on these values.
(1) Influence of filter density variation on exposure time In general, the effects of magenta and cyan filters on the exposure amount are basically the same. When each density is increased or decreased by 10, the exposure time also needs to be increased or decreased by 10%. The yellow filter has less influence on the exposure, and the exposure time differs by only 10% when there is a difference of 40 densities. Calculate the following two tables for reference when calculating the exposure time. Effects of Magenta and Cyan Filter Density Changes on Exposure Time
(2) The effect of changing the number of filter sheets on the exposure time Generally, the transmittance at the new color filter is good, and each filter differs by 10% of exposure. If the color filter is worn out and the surface is rubbed, the light transmittance will decrease, and each filter will have a difference of 15% or more in exposure time. Effect of change in the number of filters on the exposure time (3) Effect of sample size on the exposure time Exposure time is too much or insufficient, according to the amount of excess or deficiency (percentage) calculated according to the data in the table to modify the exposure time. Sample exposure density (dark and light) changes to the exposure time
Two examples are given below to illustrate the calculation method for modifying the sample exposure.
Example 1: The original sample filter combination is 60 40 00.
Exposure time: 10 seconds Filter pieces: 2
After the sample is judged by the sample bias magenta, it is estimated to increase the density of 20 magenta filters. The sample density is low, it is estimated to increase the exposure by 10%.
Therefore, the modified filter combination is 60 60 00
Check the table, increase the density of 20 magenta should be × 1.2
The number of filter sheets has not changed
Check the table, the density is too small 10% should be × 1.1
Therefore, the change exposure time is: 10 (seconds) × 1.2 × 1.1 = 13.2 (seconds)
Example 2: The original sample filter combination is 40 30 00
Exposure time: 15 seconds. Number of filters: After 2 samples, it was judged that the color was yellowish with 30 densities, the bias was 15 with density, and the pattern was lighter than 20%.
Therefore, the modified combination of color filters is: 40 30 00 +30 00 15 70 30 15 -15 15 15 55 15 00
The revised changes are:
Yellow filter increases 15 density × 1.05
Magenta filters reduce 15 densities by 0.85
Color filter increases two x 1.2
The modification of the exposure time should be:
15 (seconds) x 1.05 x 0.85 x 1.2 = 16 (seconds)
Concealer that is too light or too dense will make your makeup look unnatural. Therefore, you should choose different concealer according to your skin type to make your skin appear healthy. Paste and strip concealer have better covering effect, but the operation is more difficult; The concealer with low concealing ability can make the makeup natural because of its fresh texture. Generally, concealer is solid, but its viscosity is different. According to your own needs, you can choose to use large areas or local products.
Concealer,Private Label Concealer,Concealer Shade Finder,High Quality Concealer
Suzhou Yimeijia368 Biological Technology Co.,Ltd. , https://www.yimeijiabeauty.com