CTP platesetters also need to be very maintenance-oriented, divided into surface maintenance and internal maintenance. Good surface maintenance is only the initial maintenance of CTP machine maintenance. Internal maintenance is the key. What are the main internal maintenance of CTP platesetter? This article will tell you about it.
The CTP platesetter cleans the edge detection strip to position the image to the edge of the plate, and the output device uses an edge detection algorithm. The algorithm relies on a 741 mm (29.2 in.) black non-reflective test strip placed in the surface of the imaging drum inside the output device, which is located on the inside of the output device, on the surface of the imaging drum next to the front-edge clamp. The edge detection strip must be cleaned once a month to avoid edge detection errors.
To clean the CTP platesetter edge detection strip, follow these steps:
1. Make sure that the output device is not currently working;
2. Turn off the CTP platesetter output device;
3. Open the front door;
4. Rotate the imaging drum by hand until you see the edge detection strip;
5. Wet a piece of cotton-free cloth with distilled water and wipe the test strip only once in one direction. (Be careful not to leave any fingerprints or smudges on the test strips. Wipe dry with a clean, dry cloth after wiping.)
Article source address: http://
A dual garbage can is a bin that contains two compartments for separating the waste. You can sort your waste easily for recyling. Two-compartment recycling bins are great for home use and are also usable in the office, school, hospital, etc., or even on a boat.
double trash cans,waste bins,compartment recycling bin,Custom Trash Can
TAISHAN YUEXIN INDUSTRIAL GROUP LIMITED , https://www.gdmetalproducts.com